SunSynk INNAGATOR - Selecting the Mounting Area

Innagator | Technical Pack80
Selecting the Mounting Area
For proper heat dissipation, allow a clearance of approximately 500mm to the side, 500mm above and below
the unit, and 1000mm to the front of the unit.
DO NOT install the inverter in the following areas:
 Areas with high salt content, such as the marine environment. It will deteriorate the metal parts and
possibly lead to water/dampness penetrating the unit.
 Areaslledwithmineraloilorcontainingsplashedoilorsteam,suchasthosefoundinkitchens.Itwill
deteriorate plastic parts of the unit, causing those parts to fail or allowing water/damp to penetrate the
unit.
 Areasthatgeneratesubstancesthatadverselyaecttheequipment,suchassulphuricgas,chlorinegas,
acid, or alkali. These can cause the copper pipes and brazed joints to corrode and fail to conduct elec-
tricity reliably.
 Areasthatcancausecombustiblegastoleak,whichcontainssuspendedcarbon-breorammable
dust,orvolatileinammablesuchaspaintthinnerorgasoline.
 Areaswheretheremaybegasleaksandwheregasmaysettlearoundtheunitasthisisarerisk.
 Areas where animals may urinate on the unit or ammonia may be generated.
 High altitude areas (over 4000 metres above sea level).
 Environments where precipitation or humidity is above 95%
 Areas where the air circulation is too low.
ALSO CONSIDER:
 Installing the indoor unit, outdoor unit, power supply cable, transmission cable, and remote control cable
at least 1 metre away from any television or radio receiver. This will prevent TV reception interference or
radio noise. This will prevent radio signal interference from external units that might interfere with the
Wi-Fi or GSM monitoring.
STRICTLY, PRIVATE AND CONFIDENTIAL