SUNWARD SWDM40 - Page 163

SWDM40 OPERATION & MAINTENANCE MANUAL
162
Table 8-2-1 Maintenance or Lubrication Content and Cycle
No.
Part
Measures
Maintenance Cycle
1
Steel rope
Check abrasion
10 hours or every day
2
Drilling tool
Install and wear
10 hours or every day
3
Swing joint
regular lubrication
，
check joints,
mounting pin shaft for tightness, split
pin for wear
10 hours or every day
4
Transmission pulley shaft
and bearing (none)
regular lubrication
10 hours or every day
5
Servo-frame swing
bearing
Regular lubrication and tightness
10 hours or every day
6
Cathead main sliding
frame shaft, bearing
Regular lubrication
10 hours or every day
7
Hydraulic oil
check oil level and hydraulic oil
quality
10 hours or every day
8
Rotary drive gearbox gear
oil
check oil level
10 hours or every day
9
Rotary drive reduction
gearbox gear oil
check oil level
10 hours or every day
10
Crowd winch reduction
gearbox gear oil (none)
check oil level
10 hours or every day
11
Main winch reduction
gearbox gear oil
check oil level
10 hours or every day
12
Fuel tank
check oil level
10 hours or every day
13
Coolant
Check liquid level
10 hours or every day
14
Engine oil level
check oil level
10 hours or every day
15
Oil-water separator
draining
Check
10 hours or every day
16
Air intake pipe, water pipe
for loosen
Check
10 hours or every day
17
Crankcase breather (none)
Check
10 hours or every day
18
Drive belt, fan and bolts
Check
10 hours or every day
19
Control mechanism and
meter
Check mechanical gear or meter
function
10 hours or every day
20
Each shaft, bearing,
sliding rail and etc.
regular lubrication
50 hours or every week