SWDM40 OPERATION & MAINTENANCE MANUAL
During storage, check parts regularly, especially pipes, hoses and bolts connection for any
leakage or damage.
If damaged, eliminate that by authorized professional personnel.
Machine part and the container with capacity over than 20 L (5.3 gallon) are only allowed to
store on paved ground. (concrete or constructed as road). If the unpaved ground is the only
choice, oil and fuel should not be dropped on that.
10.3 NOTE FOR MACHINE CLEANNESS
Cover all inlets to prevent detergent, water or vapor entering, before cleaning equipment
with that. Especially, electrical parts, such as electrical box and electromotor.
Only allow to clean with special equipment on special ground where harmful liquids can’t
penetrate into.
After cleanness, check device/equipment components, especially fuel pipeline and engine oil
line. The confirmed failures should be solved.
10.4 MACHINE SHUT-DOWN
Details about machine shut-down, please see “Machine Storage”.
1）Stop the equipment.
2）Switch off the power supply.
3）Remove running media, lubrication material and attachment.
4）Shut down the machine.
10.5 MACHINE DISASSEMBLY
Preconditions：
– The machine is shut down and cleaned.
1）Disassemble the equipment and place each part onto suitable surface.
2）Disassemble the steel structure which needs to be disassembled destructively by gas-cutting
or other suitable methods.
3）Disassemble the part and classify the material separately.
4）The machine has been disassembled completely.
To Next Page
Loading...