SUNWARD SWDM40 - Maintenance for Initial 250 Hours of Operation; Changing Gear Oil for Main Winch Reduction Gearbox

SWDM40 OPERATION & MAINTENANCE MANUAL
203
8.8 MAINTENANCE FOR INITIAL 250 HOURS OF OPERATION
8.8.1 Changing Gear Oil for Main Winch Reduction Gearbox
Note！
■ Note is as the same as in the chapter 8.3.14.
FIG. 8-8-1 Reduction Gearbox of Main Winch
1
）
Remove oil drain plug of reduction gearbox and the plug of oil level sightglass, and
then reinstall the oil drain plug after gear oil is drained out;
2
）
Remove the plug of oil inlet pipe and inject new gear oil;
3
）
Stop injection till gear oil flows out from the sightglass;
4
）
Reinstall the plug of sightglass and oil inlet pipe.