SWDM40 OPERATION & MAINTENANCE MANUAL
It’s forbidden to taste the additive of coolant, because it contains cancerogenic
substance. And avoid touching with skin and eyes, if infected, please wash with clean
water at once, for a serious case, go to a doctor.
1.On the coolant tank, there are two marks “FULL”and “LOW”, and the coolant level
should be between above two marks. If the liquid level is lower than “LOW”, refill that in
time.
FIG. 7-3-20 Coolant tank
2. Procedures for filling coolant is as below:
FIG. 8-3-21 Radiator coolant filler
1
）
Screw off cover plate on the radiator filler.
2
）
Release the pressure cap slowly to discharge pressure and remove it.
3
）
Fill coolant into the cooling system with proper capacity.
4
）
Start the engine and run it without pressure cap till thermostat is turned on and coolant level
is still.
5
）
Check pressure cap spacer and replace it if damaged.
6
）
Install the pressure cap for the radiator.
7
）
Shut down the engine.
8
）
Cover the plate and fasten bolts.
To Next Page
Loading...