Supermicro X14SAE - Page 97

Power Limit 2
Use this feature to configure the value for Power Limit 2. The value is in milliwatts and the step
size is 125 mW. Use the number keys on your keyboard to enter the value. Enter 0 to use the
manufacture default setting. If the value is 0, the BIOS will set PL2 as 1.25* TDP.
C-States
Use this feature to enable the C-State of the CPU. The options are Disabled and Enabled.
Enhanced C-States
Use this feature to enable the enhanced C-State of the CPU. The options are Disabled and
Enabled.
C-State Auto Demotion
Use this feature to prevent unnecessary excursions into the C-states to improve latency. The
options are Disabled and C1.
C-State Un-Demotion
This feature allows you to enable or disable the un-demotion of C-State. The options are
Disabled and C1.
Package C-State Demotion
Use this feature to enable or disable the Package C- State demotion. The options are
Disabled and Enabled.
Package C-State Un-Demotion
Use this feature to enable or disable the Package C-State un-demotion. The options are
Disabled and Enabled.
C-State Pre-Wake
This feature allows you to enable or disable the C-State Pre-Wake. The options are Disabled
and Enabled.
Package C-State Limit
Use this feature to set the Package C-State limit. The options are C0/C1, C2, C3, C6, C7, C7s,
C8, C9, C10, Cpu Default, and Auto.
Monitor MWAIT
Select Enabled to support Monitor and Mwait, which are two instructions in Streaming SIMD
Extension 3 (SSE3) to improve synchronization between multiple threads for CPU performance
enhancement. The options are Disabled and Enabled.
97
X14SAE/X14SAE-F: UEFI BIOS