11-74 DF140 “K2” (’02) MODEL
Replacing propeller shaft oil seal
1. Remove the retaining ring 1 and washer 2.
2. Extract the seals 3 with oil seal remover.
\ 09913-50121: Oil seal remover
Do not reuse oil seal once removed.
Always use new oil seal.
3. Apply Water Resistant Grease to the inner circumference of
the housing.
WATER PUMP AND RELATED ITEMS
• Inspect impeller. Replace if vanes are cut, torn or worn.
• Inspect pump case. Replace if cracked, distorted or corroded.
• Inspect under panel. Replace if cracked, distorted or corroded.
4. Using an oil seal installer, drive the two oil seals (one at a
time) into the propeller shaft bearing housing.
The lipped portion of the seal must face towards the propel-
ler.
Apply Water Resistant Grease to the seal lips.
N 99000-25161: Water Resistant Grease
5. Install washer and retaining ring.
SHIFT ROD GUIDE HOUSING COMPONENTS
• Inspect shift rod guide housing. Replace if cracked or dam-
aged.
• Inspect shifter yoke. Replace if wear, damage or other ab-
normal condition.
• Inspect O-ring. Replace if nicked, cut, torn or swollen.
• Inspect oil seal. Replace if nicked cut or worn.
• Inspect shift rod/splines. Replace if worn, twisted or dam-
aged.
• Inspect detent ball. Replace if wear, damage or other abnor-
mal condition.
To Next Page
Loading...
