ENGINE 3-61
ENGINE REASSEMBLY
Reassemble the engine in the reverse order of disassembly.
Pay special attention to the following points:
NOTE:
Apply engine oil to each running and sliding part before reas-
sembling.
ENGINE BOTTOM SIDE
DRIVE TRAIN
• Install the driveshaft and countershaft.
• Install the shim 1.
• Install the drive bevel gear and washer 2.
• Fit the special tool onto the driveshaft.
09930-73150: Output shaft holder
• Tighten the secondary drive bevel gear nut to the specified
torque by holding the special tool with a vise.
Secondary drive bevel gear nut:
100 N·m (10.0 kgf-m, 72.5 lb-ft)
• Stake the nut with a center punch.
To Next Page
Loading...
