Suzuki Ozark - Inspection and Disassembly

7-38 CHASSIS
• Remove the steering shaft 1.
• Remove the dust seals 2 from the steering shaft.
• Remove the steering shaft holder half 3.
• Remove the steering shaft.
• Remove the dust seal 4 from the steering shaft.
INSPECTION AND DISASSEMBLY
Inspect the removed parts for the following abnormalities.
* Handlebar distortion
* Handlebar clamp wear
DUST SEALS AND O-RING
Inspect the dust seals and O-ring for wear or damage. If any
damages are found, replace the dust seals with new ones.
TIE ROD
Inspect the tie rod for distortion or damage. If any damages are
found, replace the tie rod with a new one.
1 Tie rod end
2 Locknut
3 Locknut
4 Tie rod

The locknuts 2 with a yellow finished surface have
left-hand threads.