Suzuki Ozark - Battery; Specifications; Initial Charging

ELECTRICAL SYSTEM 8-27
BATTERY
SPECIFICATIONS
a Anode plates e Stopper
b Separator (fiberglass plate) f Filter
c Cathode plates g Terminal
d Upper cover breather h Safty valve
INITIAL CHARGING
FILLING ELECTROLYTE
• Remove the aluminum tape 1 which seals the battery filler
holes 2.
• Remove the caps 3 from the electrolyte container.
NOTE:
* Do not remove or pierce the sealed areas 4 of the electrolyte
container.
* After completely filling the battery with electrolyte, use the caps
3 from the electrolyte container to seal the battery filler holes.
• Insert the nozzles of the electrolyte container 5 into the elec-
trolyte filler holes of the battery. Hold the electrolyte container
firmly so that it does not fall. Do not allow any of the electro-
lyte to spill.
• Make sure the air bubbles 1 rise to the top of each electrolyte
container and leave the electrolyte container in this position
for more than 20 minutes.
Type designation YTX12-BS
Capacity 12V, 36.0 kC (10 Ah)/10HR