Suzuki Ozark - Inspection

ELECTRICAL SYSTEM 8-19
INSPECTION
IGNITION COIL PRIMARY PEAK VOLTAGE
• Remove the fuel tank left side cover. (7-5)
• Remove the left front inner fender. (7-5)
• Remove the spark plug cap.
• Connect a new spark plug to spark plug cap and ground it to
the cylinder head.
NOTE:
Make sure that the spark plug cap and spark plug are connected
properly and the battery is fully-charged.
Measure ignition coil primary peak voltage using the multi circuit
tester in the following procedure.
• Connect the multi circuit tester with the peak voltage adaptor
as follows.
+ Probe: Black/White lead wire
- Probe: White/Blue lead wire
NOTE:
Do not disconnect the ignition coil primary wire.
 09900-25008: Multi circuit tester set

• Shift the transmission to the neutral position and turn the igni-
tion switch to the “ON” position.
• Press the starter button and allow the engine to crank for a
few seconds, and then measure the ignition coil primary peak
voltage.
• Repeat the above procedure a few times and measure the
highest ignition coil primary peak voltage.
 Tester knob indication: Voltage ()
 Ignition coil primary peak voltage: More than 120 V

If the voltage is lower than the standard values, inspect the igni-
tion coil. (8-20)
When using the multi circuit tester and peak volt adap-
tor, refer to the appropriate instruction manual.
While testing, do not touch the tester probes and
spark plug to prevent receiving an electric shock.
Peak volt adaptor
CDI
unit
Battery
New spark plug
Ignition
coil