CHASSIS 7-11
REAR WHEEL HUB
• Remove the rear wheel. (7-10)
• Remove the cotter pin and loosen the wheel hub nut by apply-
ing the rear brake.
• Remove the wheel hub nut and washer and then remove the
wheel hub 1.
INSPECTION AND DISASSEMBLY
DUST SEAL
Inspect the dust seal lips for wear or damege.
If any damages are found, replace the dust seal with a new one.
• Remove the dust seals 1 with special tool.
09913-50121: Oil seal remover
HUB BEARINGS
Inspect the inner race play of the hub bearing by hand while it is
in the wheel hub.
Rotate the inner race by hand to inspect for abnormal noise and
smooth rotation. If there is anything unusual, replace the bearing
with a new one.
• Remove the hub bearing with special tool.
09921-20240: Bearing remover set
Replace the removed dust seal with a new one.
Never reuse the removed bearings.
To Next Page
Loading...
