2-18 PERIODIC MAINTENANCE
CHASSIS BOLTS AND NUTS
Check that all chassis nuts and bolts are tightened to their specified torque. (Refer to page 2-19 and 2-20 for
the locations of the following nuts and bolts.)
Tighten initially at 1 month and every 3 months there-
after.
Item N·m kgf-m lb-ft
1 Handlebar clamp bolt 23 2.3 16.5
2 Steering shaft holder bolt 23 2.3 16.5
3 Steering shaft nut 49 4.9 35.5
4 Wishbone arm pivot nut (upper and lower) 65 6.5 47.0
5 Wheel hub nut (front) 75 7.5 54.0
6 Wheel hub nut (rear) 100 10.0 72.5
7 Wheel set nut (front and rear) 50 5.0 36.0
8 Steering knuckle nut (upper and lower) 45 4.5 32.5
9 Front shock absorber mounting nut (upper) 57 5.7 41.0
0 Front shock absorber mounting bolt (lower) 55 5.5 40.0
A Tie rod end nut 35 3.5 25.5
B Tie rod locknut 29 2.9 21.0
C Brake air bleeder valve 7.5 0.75 5.5
D Brake caliper mounting bolt 26 2.6 19.0
E Footrest bolt (M8) 26 2.6 19.0
F Footrest bolt (M10) 55 5.5 40.0
G Brake master cylinder mounting bolt 10 1.0 7.0
H Brake hose union bolt 23 2.3 16.5
I Brake pedal nut 12 1.2 8.5
J Rear brake panel nut 60 6.0 43.5
K Rear shock absorber mounting bolt (upper) 55 5.5 40.0
L Rear shock absorber mounting nut (lower) 60 6.0 43.5
M Rear swingarm pivot nut 85 8.5 61.5
To Next Page
Loading...
