Suzuki Ozark - REAR DRIVE REASSEMBLY

DRIVE TRAIN 4-11
REAR AXLE
Inspect the splines of the rear axle and splines of the ring gear
for wear or damage.
If any wear or damage is found, replace the rear axle and ring
gear with the new ones.
REAR DRIVE REASSEMBLY
Reassemble the rear drive in the reverse order of disassembly.
Pay attention to the following points:
NOTE:
Before reassembly, thoroughly clean all parts in cleaning sol-
vent.
GEAR CASE OIL SEAL
• Install the new oil seals into the gear case and case cover
with the special tool.
• Apply grease to the new oil seal lips.
 09913-70210: Bearing installer set
 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
NOTE:
The marked side on the oil seal should be positioned outside.
(4-21)