Suzuki Ozark - Reassembly and Remounting

7-40 CHASSIS
• Install the steering shaft bushing with the special tool.
 09924-84510: Bearing installer set
REASSEMBLY AND REMOUNTING
Reassemble and remount the steering stem in the reverse order
of removal and disassembly. Pay attention to the following
points:
STEERING SHAFT
• Apply SUZUKI SUPER GREASE “A” to the O-ring, dust seals
and steering shaft before remounting the steering shaft.
 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
• Install the dust seal 1 to the steering shaft.
• Install the circlip 2 to the dust seal.
• Install the new O-ring 3 and dust seal to the steering shaft.
• Tighten the steering shaft nut to the specified torque.
 Steering shaft nut: 49 N·m (4.9 kgf-m, 35.5 lb-ft)
• Install the cotter pin.

Replace the removed cotter pin with a new one.