Suzuki Ozark - Page 117

ENGINE 3-77
• Bend up the washer tongue positively to lock the bolts.
• Install the C-ring 1.
CYLINDER HEAD COVER
• Clean the mating surface of the cylinder head and head cover
before matching.
• Install the dowel pins to the cylinder head.
• Apply SUZUKI BOND “1216B” to the mating surface of the
cylinder head cover.
• Fit the camshaft end cap 1.
99000-31230: SUZUKI BOND “1216B”
• Lightly tighten the cylinder head cover bolts diagonally, and
then if everything is satisfactory, tighten securely with a
torque wrench to the specified torque.
 Cylinder head cover bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
NOTE:
* When tightening the cylinder head cover bolts, the piston must
be at top dead center on the compression stroke.
* Fit the washer to the bolt A.
Camshaft
Pin
Bend up
Bolt
Washer
Sprocket
1216