Suzuki Ozark - Page 187

CHASSIS 7-23
• Apply SUZUKI SILICONE GREASE to the brake caliper
holder slide pin.
 99000-25100: SUZUKI SILICONE GREASE
• Install the pin 1, washer 2 and caliper holder 3 to the cali-
per.
• Apply THREAD LOCK SUPER “1360” to the pin 1.
99000-32130: THREAD LOCK SUPER “1360”
• Tighten the pin 1 to the specified torque.
 Caliper holder slide pin: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
• Install the pads and spring to the caliper.
• Tighten the brake pad mounting pins 4, brake caliper mount-
ing bolts 5 and brake hose union bolt 6 to the specified
torque.
 Brake pad mounting pin: 18 N·m (1.8 kgf-m, 13.0 lb-ft)
Brake caliper mounting bolt:
26 N·m (2.6 kgf-m, 19.0 lb-ft)
Brake hose union bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
NOTE:
Before remounting the brake caliper, push the brake caliper pis-
tons all the way into the caliper.

Bleed air from the system after reassembling the
brake caliper. (2-14)