CHASSIS 7-31
KNUCKLE END
Inspect the knuckle end boot for wear or damage. If any dam-
ages are found, replace the knuckle end with a new one.
Inspect the knucle end for smooth movement. If there are any
abnormalities, replace the tie rod end with a new one.
• Remove the snap ring.
• Remove the knuckle end by using the special tools.
09913-70210: Bearing installer set
WISHBONE ARM
Inspect the wishbone arm for wear or damage. If any damages
are found, replace the wishbone arm with a new one.
Inspect the rubber bushing for wear or damage. If any damages
are found, replace the bushing with a new one.
To Next Page
Loading...
