CHASSIS 7-33
• Degrease the tapered portion of knuckle and also knuckle end
with nonflammable cleaning solvent.
• Install the wishbone arms to the knuckle and tigten the
knuckle nuts to the specified torque.
Knuckle nut: 45 N·m (4.5 kgf-m, 32.5 lb-ft)
• Install the cotter pins.
• Apply THREAD LOCK SUPER “1303” or “1322” to the wish-
bone arm pivot bolts 1, and then tighten the nuts to the spec-
ified torque.
99000-32030: THREAD LOCK SUPER “1303” (USA)
99000-32110: THREAD LOCK SUPER “1322” (Others)
Wishbone arm pivot nut: 65 N·m (6.5 kgf-m, 47.0 lb-ft)
• Install the rear shock absorber 2.
• Tighten the shock absorber mounting bolt/nut 3 to the speci-
fied torque.
Shock absorber upper mounting nut:
57 N·m (5.7 kgf-m, 41.0 lb-ft)
Shock absorber lower mounting bolt:
55 N·m (5.5 kgf-m, 40.0 lb-ft)
• Apply THREAD LOCK SUPER “1360” to the disc cover
mounting bolts, and then tighten the bolts.
99000-32130: THREAD LOCK SUPER “1360”
Replace the removed cotter pins with new ones.
To Next Page
Loading...
