SERVICE DATA
CARBRETOR
FUEL + OIL
ITEM
SPECIFICATION
* E-24 E-17 * E-28, 33
Carburetor type MIKUNI BS29 ←←
Bore size 29 mm ←←
I.D. No. 05G0 05G2 05G1
Idle r/min 1 500 ± 100 r/min ←←
Float height 17.1 ± 1.0 mm
(0.67 ± 0.04 in)
←←
Main jet (M.J.) #137.5 ← #
Jet needle (J.N.) 4DJ24-1st ←←
Needle jet (N.J.) P-0M ←
Throttle valve (Th.V.) #100 ←←
Pilot jet (P.J.) #17.5 ← #
Pilot screw (P.S.) 2 and 7/8 turns back ← PRE-SET
Throttle cable play 3 – 5 mm
(0.12 – 0.20 in)
←←
Starter (enricher) cable play 0.5 – 1.0 mm
(0.02 – 0.04 in)
←←
TEM SPECIFICATION NOTE
Fuel type Use only unleaded gasoline of at least 87 pump
octane (R/2 + M/2) or 91 octane or higher rated by
the research method.
Gasoline containing MTBE (Methyl Tertiary Butyl
Ether), less than 10% ethanol, or less than 5%
methanol with appropriate cosolvents and corro-
sion inhibitor is permissible.
E-28, 33
Gasoline used should be graded 91 octane or
higher. An unleaded gasoline is recommended.
E-17, 24
Fuel tank capacity including
reserve
* 9.7 L
(2.6/2.1 US/lmp gal)
reserve
* 2.1 L
(0.6/0.5 US/lmp gal)
Engine oil type SAE 10W-40, API SF/SG or SH/SJ with JASO MA
Engine oil capacity
Change
2 200 ml
(2.3/1.9 US/lmp qt)
Filter
change
2 300 ml
(2.4/2.0 US/lmp qt)
Overhaul
2 500 ml
(2.6/2.2 US/lmp qt)
Rear drive (final) gear oil type Hypoid gear oil SAE #90, API grade GL-5
Rear drive (final) gear oil capacity 190 ml
(6.4/6.7 US/lmp oz)
LT-F250K9 ('09 MODEL) 16-3
To Next Page
Loading...
