16-8 FRONT FORK AND STEERING
• Attach the stopper ring 7 securely to the stopper ring groove
of the outer tube.
• Attach the dust seal 8.
NOTE:
After attaching the dust seal, make sure that there are no cracks
around the circumference of the seal. Cracks could allow water,
mud and the like to enter and cause an oil leak.
• Install the damper rod into the front fork.
• Apply THREAD LOCK SUPER “1322” to the front fork center
bolt.
99000-32110: THREAD LOCK SUPER “1322”
• Apply fork oil to the O-rings.
• Tighten the front fork center bolt to the special torque with the
special tool.
Front fork center bolt: 55 N·m (5.5 kgf-m, 40.0 lb-ft)
09940-30250: Front fork assembling tool
• Install the spring guide 1, lock-nut 2 onto the inner rod.
CAUTION
Use of grease as a substitute fork oil when installing
the oil seal can result in an oil leak. Applying grease to
the dust seal and oil seal can cause dirt to accumulate
and damage the dust seal lip and oil seal lip.
Use only a thin coat of fork oil on the oil seal.
To Next Page
Loading...
