Command Line Interface
5-33
flow-control
Use the flow-control command to enable or disable the flow control for a port.
interface <port>
flow-control
no flow-control
S
YNTAX DESCRIPTION:<port> Port instance
D
EFAULT VALUE: The flow control feature is enabled by default.
C
OMMAND MODES: Interface configuration
R
EFERENCE:Cisco
M
ENU: Basic Switch Configuration Menu->Port->Set Flow control
E
XAMPLE:
! Enable Flow control port-3
Switch(config)# interface fastethernet0/3
Switch(config-if)# flow-control
Switch(config-if)#
! Disable Flow control port-25(giga port)
Switch(config)# interface fastetherne0/3
Switch(config-if)# no flow-control
Switch(config-if)#
show interface info
Use the show interface info command to display port information.
show interface
S
YNTAX DESCRIPTION: The show interface info command has no arguments or keywords.
D
EFAULT VALUE: The show interface info command has no default setting.
C
OMMAND MODES: Privileged EXEC
R
EFERENCE: Nortel
M
ENU: Basic Switch Configuration Menu -> Port Configuration Menu
To Next Page
Loading...
