Symbol ES3000 - 5.14 Quality of Service Commands

Command Line Interface
5-81
5.14 Quality of Service Commands
mls qos
Use the mls qos command to enable or disable the QoS implemented in the system.
mls qos
no mls qos
S
YNTAX DESCRIPTION: The mls qos command has no argument.
D
EFAULT VALUE: The feature is disabled by default.
C
OMMAND MODES: Global configuration
R
EFERENCE:Cisco
M
ENU: Advanced Switch Configuration Menu->Quality of Service->Set Status
E
XAMPLE:
!Disable Quality of Service
Switch(config)# no mls qos
Switch(config)#
!Enable Quality of Service
Switch(config)# mls qos
Switch(config)#
priority-queue cos-map
Use the priority-queue cos-map command to map the 802.1p traffic class to the port transmitting
queues.
priority-queue cos-map <traffic class> <priority>
S
YNTAX DESCRIPTION: <priority> Integer ranges from 0 to 7.
<traffic class> 0 to 3, 0 is lowest, 3 is highest
D
EFAULT VALUE:
C
OMMAND MODES: Global configuration
R
EFERENCE:Cisco
M
ENU: Advanced Switch Configuration Menu->Quality of Service->
Set Priority Queue