Administration Console Access
3-17
3.5.7 Main Menu->SNMP Config.->Authorized Managers
Use the Authorized Managers page to list the SNMP managers and their associated information.
There are two community strings in default mode, private and public. Read-only is allowed with public
and read-write is granted to private. Change the two community strings as required.
Four commands are available to set the Manager IP, community string, Status, Privilege, and IP
address.
Set Manager IP: Sets the IP address of a specified community. The access is
restricted to specified IP only.
Set Manager Community: Sets community string.
Set Manager Privilege: Sets the access privilege, 1 is Read-only and 2 is Read-Write.
Set Manager Status: Enables or disables a community string.
To Next Page
Loading...
