Symbol ES3000 - Page 265

Command Line Interface
5-97
dot1x timeout quiet-period
Use this command to set the number of seconds the switch remains in quiet state following a failed
authentication exchange with the client.
dot1x timeout quiet-period <second>
S
YNTAX DESCRIPTION: <second> Set the number of seconds
D
EFAULT VALUE:
C
OMMAND MODES: Interface configuration
R
EFERENCE:Cisco
M
ENU:
E
XAMPLE:
! Set quiet period time 60 sec on port 7
Switch(config)# interface fastethernet0/7
Switch(config-if)# dot1x timeout quiet-period 60
Switch(config-if)#
dot1x timeout server
Use this command to set the number of seconds the switch waits for a response to a RADIUS frame.
dot1x timeout server <second>
S
YNTAX DESCRIPTION: <second> Set the number of seconds
D
EFAULT VALUE:
C
OMMAND MODES: Interface configuration
R
EFERENCE:Cisco
M
ENU:
E
XAMPLE:
! Set transmit time 10 sec on port 3
Switch(config)# interface fastethernet0/3
Switch(config-if)# dot1x timeout server 10
Switch(config-if)#