Command Line Interface
5-105
sntp daylight-saving
Use this command to enable or disable daylight saving, if time zone is applicable.
sntp daylight-saving
no sntp daylight-saving
S
YNTAX DESCRIPTION: This command has no argument.
D
EFAULT VALUE: This command is disabled by default
C
OMMAND MODES: Global configuration
R
EFERENCE: None
M
ENU: Basic Switch Configuration Menu->SNTP Configuration->
Set Daylight Saving
E
XAMPLE:
!Enable daylight saving.
Switch(config)# sntp daylight-saving
Switch(config)#
!Disable daylight saving.
Switch(config)# no sntp daylight-saving
Switch(config)#
sntp timezone
Use the sntp timezone command to configure the timezone.
show timezone <location>
S
YNTAX DESCRIPTION: This location type ranges from 1 to 63.
D
EFAULT VALUE:
C
OMMAND MODES: Global configuration
R
EFERENCE: None
M
ENU: Basic Switch Configuration Menu->SNTP Configuration->
Set time Zone
To Next Page
Loading...
