100
(Continued)
Network standby
“Standby Mode”
When this function is set to “On”, then this unit
automatically turns on in the following cases.
When a Bluetooth
®
connection is established to
this unit from a paired Bluetooth
®
device.
When playback operations are performed on this
unit from a device connected to the network.
• The factory default is “On”. To disable this
function, select “Off”.
• This setting is not displayed while the network
function is disabled. (“Pure Amplification” is set
to “On” or “Network/USB-A/Bluetooth” is set to
“Disabled”) (⇒ 64)
Network settings
“Network”
Wi-Fi setting
“Wi-Fi Menu”
The wireless LAN function can be enabled or
disabled.
• The factory default is “On”.
Displaying the network icon
“Network Indicator”
Set to “Off” to turn the network icon (Wired LAN /
Wireless LAN) off from the display.
• The factory default is “On”.
Wi-Fi signal strength
“Signal Level”
To check the Wi-Fi signal strength where this system
is located.
• The signal strength is shown as 3 (max) - 2 - 1. If
the indicator shows “2” or “1”, change the position
or angle of your wireless router or this system, and
see if the connection improves.
• If “0” is displayed, this system cannot establish a
link with the wireless router.
To Next Page
Loading...
Need help?
General
