112
(Continued)
Others
Troubleshooting
Before requesting service, make the
following checks. If you are uncertain about
some of the check points, or if the solutions
indicated in the following guide do not
resolve the issue, then consult your dealer
for instructions.
Heat buildup of this unit
This unit becomes warm while in use.
• Be careful when touching the bottom of this unit
because the bottom of this unit may be hot. For
installation or unit care, disconnect the AC mains
lead, wait for at least 3 minutes.
Do you have the latest firmware
installed?
Panasonic is constantly improving the unit’s
firmware to ensure that our customers are enjoying
the latest technology. (⇒ 101)
To restore all the settings to the
factory defaults
When the following situations occur, reset the
memory:
• There is no response when buttons are pressed.
• You want to clear and reset the memory contents.
1 Press [SETUP] while this unit is turned
on.
2 Press [
], [ ] repeatedly to select
“Initialization” and then press [OK].
3 Press [
], [ ] to select “Yes” and then
press [OK].
• A confirmation screen appears. Select “Yes” in
the following steps to restore all the settings to
defaults.
4 Press [ ], [ ] to select “Yes” and then
press [OK] again.
To Next Page
Loading...
Need help?
General
