113
(Continued)
General
The unit does not work.
Operations are not done properly.
• One of the unit’s safety devices, etc. may have
been activated.
Press [ ] on the unit to switch the unit to
standby.
• If the unit does not switch to standby, press
[
] on the unit for at least 5 seconds. The
unit is forcibly switched to standby.
Alternatively, disconnect the AC mains lead,
wait for at least 3 minutes, then reconnect it.
Press [ ] on the unit to switch on. (It may take
some time for this unit to be turned on.)
• If the operations are not done properly yet
even after turning this unit on, press and hold
[
] at least 5 seconds to turn off. (Release
the button after turning off.) It may solve the
problem.
• If the unit still cannot be operated, consult the
dealer.
• The remote control may not work properly.
(⇒ 120)
A “humming” sound can be heard during
playback.
• An AC mains lead of another device or fluorescent
light is near the cables. Turn off other appliances,
or keep them away from the cables of this unit.
• A strong magnetic field near a TV or other device
may adversely affect the audio quality. Keep this
unit away from such a location.
• The speakers may output noise when a device
nearby is emitting powerful radio waves, such as
when a mobile phone is on a call.
No sound.
• Check to see if the cable connections to the input
and output terminals are incorrect. If this is the
case, turn this unit to standby and reconnect the
cables correctly.
• Check to see if the correct input source is selected.
• Insert the plugs of the cables to be connected all
the way in.
• Confirm the sound output setting. (Sound is
not output from the speakers connected to the
speaker output terminals of this unit while “PRE
OUT” is set to “On (Speaker: Off)”.) (⇒ 110)
• Sound is not output from PRE OUT terminals while
“PRE OUT” is set to “Off”. (The factory default is
“Off”.) (⇒ 110)
• When a plug is connected, the speakers and PRE
OUT terminals do not output sound. (⇒ 109)
• Playback of multi-channel content is not
supported.
• The digital audio input terminal of this unit can
only detect linear PCM signals. For details, refer to
the operating instructions of the device.
To Next Page
Loading...
