Technics SU-GX70

109
Settings
Connecting a power amplifier,
subwoofer, etc.
(Continued)
You can connect the power amplifier,
subwoofer, etc. with analogue audio cable
(not supplied) to output the analogue audio
signals.
Power amplifier, Subwoofer, etc.
Analogue audio cable
(not supplied)
Do not input the audio signal from PRE
OUT terminals to the analogue audio input
terminals of this unit. Doing so may cause
malfunction.
Using analogue audio cable
1 Disconnect the AC mains lead.
2 Connect this unit and a power amplifier,
subwoofer, etc.
3 Connect the AC mains lead to this unit.
(⇒ 27)
4 Press [
] to turn this unit on.
Note
• If the connected equipment only has monaural
audio input, connect to either L or R of PRE OUT
terminals of this unit.
• For details, refer to the operating instructions of
the connected device.