Technics SU-GX70

120
(Continued)
Remote control
The remote control does not work properly.
• The batteries are depleted or inserted incorrectly.
(⇒ 21)
• To avoid interference, please do not put any
objects in front of signal sensor. (⇒ 17)
• If the remote control mode of the remote control
differs from that of this unit, match the mode of
the remote control to the mode of this unit. (⇒ 21)
Messages
Auto Off
The unit has been left unused for about 20 minutes
and will shut down within a minute. (⇒ 98) Press
any button to cancel it.
Checking Device
The unit is checking the connected USB device.
• After this display has disappeared, start operating.
Connect to Network
Connect this unit to the network and then wait for
the start of the Firmware Update via Internet.
(⇒ 102)
Connect USB Device
• Download the latest firmware on the USB flash
memory and try again. (⇒ 102)
Disconnect PHONES
When the headphones are connected, measuring
the output signal of the amplifier (LAPC) will not
start.
• Disconnect the headphones.
• If you connect headphones during amplifier signal
measurement or amplifier output correction, it will
be cancelled. (⇒ 104)
Download Fail
The firmware download has failed.
The network is not connected to the internet.
• Press any button to exit. Please try again later.
• The server cannot be found. Press any button to
exit. Make sure that the network is connected to
the internet.