Technics SU-GX70 User Manual

31
(Continued)
Wireless LAN connection
■
Preparation
Disconnect the AC mains lead.
Disconnect the LAN cable.
Place this unit as close to the wireless router as
possible.
Point up the antenna on the rear of this unit as
shown in the figure.
Connect the AC mains lead to this unit. (⇒ 27)
Note
• The setting will be cancelled after the set time
limit. In that case, try the setting again.
• To cancel this setting in the middle, press [
] or
turn the unit to standby mode.
• When the connection is established, “
” is
displayed. (⇒ 35)
Network setting for the first time using
the app
1 Press [ ] to turn this unit on.
• “Wi-Fi Setup” is displayed.
2 Press [ ], [ ] to select “Yes” and then
press [OK].
• “Setting” is displayed.
(Using Google Home app)
3 Open the Google Home app and follow
the on-screen instructions. (⇒ 35)
(Using Apple Home app)
3 Open Apple Home app and follow
the on-screen instructions to set up a
connection. (⇒ 35)

Technics SU-GX70 Specifications

General

Type	Integrated Amplifier
Input Impedance	47 kΩ
Speaker Impedance	4Ω - 16Ω
USB-A Playback	Yes
Power Supply	AC 220-240V, 50Hz/60Hz
Power Consumption	65 W
Input Sensitivity	200 mV
Digital Audio Inputs	Coaxial
Analog Audio Inputs	RCA
Analog Audio Outputs	RCA x1
Headphone Output	Yes
Ethernet Interface	Yes
Wi-Fi	Yes
Bluetooth	Yes (4.2, A2DP, SBC, AAC)
Streaming Services	Spotify, TIDAL, Deezer, Internet Radio