Technics SU-GX70

110
Setting the audio output
(PRE OUT)
You can set the audio output of the speaker output
terminals and PRE OUT terminals.
1 Press [SETUP].
2 Press [
], [ ] repeatedly to select “PRE
OUT” and then press [OK].
3 Press [
], [ ] to select the output
setting and then press [OK].
• The factory default is “Off”.
On:
Sound is output from the speaker output
terminals and PRE OUT terminals.
On (Speaker: Off):
Sound is not output from the speaker output
terminals. Sound is output from PRE OUT
terminals.
Off:
Sound is not output from PRE OUT terminals.
Sound is output from the speaker output
terminals.
Note
• It is recommended to set to “On (Speaker: Off)”
when connecting a power amplifier.
• Set “LAPC” to “Off” when connecting a power
amplifier, etc. to PRE OUT terminal to use because
the correction function (LAPC) effects on the
audio output from PRE OUT terminal. (⇒ 104)