Technics SU-GX70 User Manual

21
(Continued)
Using the remote control
2
1
R03/LR03, AAA
(Alkaline or manganese batteries)
Note
• Insert the battery so the terminals ( and )
match those in the remote control.
• Point it at the remote control signal sensor on this
unit. (⇒ 17)
• Keep the batteries out of reach of children to
prevent swallowing.
Remote control mode
When other equipment responds to the supplied
remote control, change the remote control mode.
• The factory default is “Mode 1”.
1 Press [SETUP].
2 Press [
], [ ] to select “Remote
Control” and then press [OK].
• The current remote control mode of this unit is
displayed.
3 When “Set Mode 1/2” is displayed,
change the remote control mode of the
remote control.
To set “Mode 1”:
Press and hold [OK] and [1] for at least
4 seconds.
To set “Mode 2”:
Press and hold [OK] and [2] for at least
4 seconds.
4 Point the remote control at this unit,
and press and hold [OK] for at least
4 seconds.
• When the remote control mode is changed, the
new mode will appear on the display for a few
seconds.

Technics SU-GX70 Specifications

General

Type	Integrated Amplifier
Input Impedance	47 kΩ
Speaker Impedance	4Ω - 16Ω
USB-A Playback	Yes
Power Supply	AC 220-240V, 50Hz/60Hz
Power Consumption	65 W
Input Sensitivity	200 mV
Digital Audio Inputs	Coaxial
Analog Audio Inputs	RCA
Analog Audio Outputs	RCA x1
Headphone Output	Yes
Ethernet Interface	Yes
Wi-Fi	Yes
Bluetooth	Yes (4.2, A2DP, SBC, AAC)
Streaming Services	Spotify, TIDAL, Deezer, Internet Radio