Technics SU-GX70

105
■
Turning on/off the output correction function
1 Press [SETUP].
2 Press [
], [ ] to select “LAPC” and then
press [OK].
3 Press [
], [ ] to select “On”/“Off” and
then press [OK].
Note
• The setting status of LAPC is displayed by pressing
and holding [INFO].
• Set to “Off” when using output correction
function for the connected speakers because the
correction function (LAPC) effects on the audio
output from PRE OUT terminal. (⇒ 109)
• Depending on the type of the connected speakers,
the effect of the output correction function may
be minimal.
• The corrected output remains in effect until you
measure the output signal again. When you use
other speakers, redo the measurement.