Technogym CROSS FORMA - Required Tools

CROSS FORMA: Service & Maintenance Manual - rev. 2.1
Page 11.2
11.2. REQUIRED TOOLS
The following tools are required for carrying out the various disassembly, adjustment and
maintenance action on the machine:
• Small Phillips screwdriver;
• Medium Phillips screwdriver;
• 13-mm wrench;
• 15-mm wrench;
• 17-mm wrench;
• 3-mm Allen T-wrench;
• 4-mm Allen T-wrench;
• 5-mm Allen T-wrench;
• 6-mm Allen T-wrench;
• 8-mm Allen T-wrench;
• Snap ring pliers;
• Ring nut spanner;
• Torque wrench;
• Flatness comparator.
ATTENTION: The tool sizes are expressed in mm.