Technogym CROSS FORMA - Machine Error History Log

CROSS FORMA: Service & Maintenance Manual - rev. 2.1
Page 9.8
9.2.2.1. Read from low kit
To read the parameter values from the low kit memory and view them on the display, scroll using
the +/- keys until the display shows:
READ FROM LOW KIT ?
press ENTER to read the parameters from the low kit, and return to the upper menu level by
pressing CLEAR for a few seconds.
9.2.2.2. Write to low kit
To write the values of the currently displayed parameters to the low kit, scroll using the +/- keys
until the display shows:
WRITE TO LOW KIT ?
press ENTER to write the new data to the low kit, and return to the upper menu level by pressing
CLEAR for a few seconds.
9.2.2.3. Machine usage data
The machine usage data on the display is updated every 10 minutes. This means that, whenever the
machine is switched off, any data modified after the last memory update will be lost.
MESSAGE ON DISPLAY
DESCRIPTION
Life Brake:
Minutes x 10 of operation of the brake
Life Kit H:
Minutes x 10 of operation of the upper assembly
Life Kit L:
Minutes x 10 of operation of the lower assembly
Tot. Km:
Total Km done
KJ
Total KJ during exercise
By selecting one of the items in the above table it is possible to modify its content, but only after
having cleared its value. When the ENTER key is pressed the message “Reset life...” appears,
followed by the name of the selected item; pressing ENTER again resets the value of the selected
item, while pressing CLEAR reverts to the preceding value.
9.2.3. ERRORS LOG
This function accesses the machine's error history log. To access this menu, when the display
shows:
ERRORS LOG
press ENTER. This function is structured as follows: