Technogym CROSS FORMA - Service Menu Technical Configuration

CROSS FORMA: Service & Maintenance Manual - rev. 2.1
Page 9.5
9.2. SERVICE MENU CONFIGURATION
The configuration procedure is invoked when the machine is in standby mode. Simultaneously press
the keys 369. The following prompt appears on the display:
ENTER PASSWORD:
To access the procedure, type in the password 2501 which protects against unauthorized access and
press the “Enter” key to confirm. At this point there are two options available:
1 = Tech Config
2 = Troubleshooting
Press numeric key 1 to access the menu for configuring technical parameters; the machine display
will begin showing the current configuration, structured as in the diagram below:
• Configuration
TECHNICAL
CONFIGURATION
ERRORS LOG
HIGH KIT
VERSION
LOW KIT
PARAM.
OPERATING
DATA
BOOT
VERSION
LOW KIT
MENU
STANDARD
SETTINGS
To scroll through the list of parameters, press the + or – effort level keys to display the next or the
preceding item.
To modify a parameter value, it is necessary to press the ENTER key: when the current parameter
value starts to blink, press the CLEAR key to erase the current value and then use the number keys
to enter the desired new value. Press ENTER to save the changes made.
To cancel the operation, press the CLEAR key for a few seconds.
The various parameters are described below.
9.2.1. LOW KIT PARAMETER
This function provides access to parameters used for modifying certain settings of the lower
assembly. To access this menu, when the display shows:
LOW KIT PARAM.