Technogym CROSS FORMA - Disassembling the Speed Sensor

CROSS FORMA: Service & Maintenance Manual - rev. 2.1
Page 7.23
7.15. DISASSEMBLING THE SPEED SENSOR
Figure 7.15-1
Carry out the procedure described in paragraph
7.6. “Disassembling the guards
” only
disassembling the right casing.
1.
Unplug the fastom indicated in the figure to
side.
2. Cut the cable tie a.
3. Back off the 2 screws b
using a small Phillips
screwdriver.
4. Remove the speed sensor.
If the sensor support is also removed,
adjust the sensor position as described
in paragraph 8.2. “
Speed sensor
position”.
To reassemble the speed s
ensor, carry out the
above steps in reverse order.