Technogym CROSS FORMA - Resolving Incorrect Resistance Issues

CROSS FORMA: Service & Maintenance Manual - rev. 2.1
Page 6.12
6.6. THE RESISTANCE IS INCORRECT
The equipment produces an incorrect resistance if:
1. the mechanics are not perfect;
2. the speed as measured is not correct;
3. the Brake Board is faulty;
4. the Brake Board was not programmed correctly with the sequence of:
a. Firmware (FW),
b. Brake Table;
c. Standard Settings.
5. the Electromagnetic Brake is faulty.
Are the mechanics of the
machine in good condition?
Does the Brake Board output
the correct current to the brake
winding?
Replace the
Brake Board
NO
Replace the Brake
winding
HE RESISTANCE IS
INCORRECT
2
Repair the faulty
mechanical parts
NO
Carry out the "Speed
signal is Incorrect"
troubleshooting procedure
3
Install the latest v ersion of
Firmware (FW), Brake Table
and carry out the Standard
Setting.
1
YES
YES