Technogym SELECTION 700 - Page 90

4b
5. Remove the screw
[4b] with the relative
washer on the right
side. (TOOL: ratch-
et with 4 mm hex-
agonal bit). Repeat
the same procedure
on the other side of
the equipment for
the special nut.
During the reassem-
bly procedure,
apply some glue
to the special nut
to prevent it from
moving.
6. Remove the four
screws highlighted
in red in the gure.
(TOOL: 5 mm hexa-
gon key wrench).
SELECTION 700 Technical Service Guide
Rev. 2.0
- 92 - Document uncontrolled when printed