Teknic CLEARPATH-EC - Ethercat Parameters Menu

C LEAR P ATH -EC U SER M ANUAL REV 1.11 63
Power and Temperature Settings and Status. Use these settings to:
x Configure ClearPath to shut down or issue a warning when DC
bus voltage falls below the Low Voltage Exception Threshold.
x Change Bus Current Trip Point. This parameter is commonly
left at the default value.
x View the current temperature of the ClearPath drive board.
x Set the Maximum Drive Temperature (the threshold at which
ClearPath will throw an over-temperature shutdown.)
E THER CAT P ARAMETERS M ENU
EtherCAT Parameters Menu
EtherCAT Parameter Editor. Lets the user modify EtherCAT
parameters manually within ClearView 3.0.
T
EKNIC , I NC . T EL . (585) 784-7454