Teknic CLEARPATH-EC - Power-Up Procedure

C LEAR P ATH -EC U SER M ANUAL REV 1.11 16
P OWER -U P P ROCEDURE
1. IMPORTANT: Start with power supplies turned off. See note
below.
2. Connect cables as shown earlier in this section.
3. Turn on power supplies.
IMPORTANT: Remove DC Bus Power whenever connecting or
disconnecting a power cable from your motor's M12 power connector.
Removing power will prevent electrical arcing from damaging the motor
and connector terminals.
T
EKNIC , I NC . T EL . (585) 784-7454