C
LEAR
P
ATH
-EC
U
SER
M
ANUAL REV
1.11
7
x ClearPath motors require that a conductive path exist between
the motor chassis and the Protective Earth (PE) connection of
the machine to which it is affixed. (Note: The PE connection is
often satisfied by simply bolting the motor to the machine;
however it is the users responsibility to verify the PE
connection.) If an external grounding wire is required, use the
same or larger wire gauge as used between the DC power supply
and ClearPath Motor.
x Any maintenance or repair guide created by the user shall state
that power shall be removed before the Protective Earth ground
conductor is disconnected. When reconnecting power, the
Protective Earth ground conductor shall be the first wire
reconnected. Main power may be reconnected only after the
Safety Ground connection is secure.
G
ENERAL
D
ISCLAIMER
The User is responsible for determining the suitability of products for
their different applications. The User must ensure that Teknic's products
are installed and utilized in accordance with all local, state, federal and
private governing bodies and meet all applicable health and safety
standards.
Teknic has made all reasonable efforts to accurately present the
information in the published documentation and shall not be responsible
for any incorrect information which may result from oversights. Due to
continuous product improvements, the product specifications as stated in
the documentation are subject to change at any time and without notice.
The User is responsible for consulting a representative of Teknic for
detailed information and to determine any changes of information in the
published documentation.
If Teknic’s products are used in an application that is safety critical, the
User must provide appropriate safety testing of the products, adequate
safety devices, guarding, warning notices and machine-specific training to
protect the operator from injury.
T
EKNIC
,
I
NC
. T
EL
.
(585)
784-7454
To Next Page
Loading...
