Teknic CLEARPATH-EC - Clearview 3.0 Menus; File Menu

C LEAR P ATH -EC U SER M ANUAL REV 1.11 54
C LEAR V IEW 3.0 M ENUS
F ILE M ENU
File Menu
Load Configuration. Used to load motor configuration files into your
ClearPath-EC motor. The file extension is .mtr.
Load Recent. Lets you select a motor configuration file from a list of the
most recently saved .mtr files.
Save Configuration. Used to save your ClearPath-EC motor
configuration file as a .mtr file.
Reset Config File to Factory Defaults. Restores ClearPath-EC to its
factory default configuration (i.e., the way it was configured when you
received it). All existing settings will be overwritten. Save your current
configuration as a .mtr file (described above) if you think you'll need to
use it some other time.
Preferences. Used to select COM ports and turn Event Sounds on or off.
Create Support Package. Creates a .zip file containing comprehensive
system diagnostic data. Typically for use by a Teknic application engineer.
Firmware Update. Use this command to update your motor's firmware.
T
EKNIC , I NC . T EL . (585) 784-7454