Teknic CLEARPATH-EC - Page 53

C LEAR P ATH -EC U SER M ANUAL REV 1.11 53
8 Cursor Readings Displays time and amplitude measurements of the
vertical and horizontal cursors on your scope display. Click the Measure
Move button to automatically place the vertical cursors at the beginning
and end of a move to quickly determine total move time. Click Reset
Cursors if cursors are not visible.
9 I/O Display Setup Sets I/O-A and I/O-B to display as either an input
or an output on the strip chart.
T
EKNIC , I NC . T EL . (585) 784-7454