Tektronix 2232 - Characteristic Tables; Table A-4: Electrical Characteristics

Appendix 6: Specification
Characteristic Tables
The characteristics listed in the tables that follow are valid when the perfor-
mance conditions just listed are met.
Items listed in the "Performance Re-
quirements" column are verifiable qualitative or quantitative limits that define
the measurement capabilities of the oscilloscope.
Environmental characteristics are given in Table A-5 on page A-22. This
oscilloscope meets the requirements of MIL-T-28800D for Type
Ill, Class 5
equipment, except where noted otherwise.
Physical characteristics of the oscilloscope are listed in Table A-6 on
page A-23.
Table
A-4: Electrical Characteristics
Characteristics Performance Requirements
ppppp -
Vertical Deflection System
Deflection Factor
Range
--
-
2 mV per division to 5 V per division in a 1-2-5 sequence.
DC Accuracy (NON-STORE)
+15O C to +3S0 C
t3%.'
For 5 mV per division to 5 V per division VOLTSIDIV switch
settings, the gain is set at a VOLTSIDIV switch setting of
10
mV per division.
2
mV per division gain is set with the VOLTSIDIV switch set to
2
mV per division.
On Screen DC Accuracy (STORE)
+IS0 Cto +35" C 22%.
+3%.1
Gain set with the VOLTSIDIV switch set to 5 mV per division.
pp - - - - -
-
Storage Acquisition Vertical Resolution 8-bits, 25 levels per division. 10.24 divisions dynamic range.'
Range of
VOLTSIDIV Variable control Continuously variable between settings. Increases deflection
4
-
factor by at least 2.5 to 1.
A
1Performance requirement not checked in manual.
!e
Appendices
Y