Tektronix 2232 - Table A-1 0: Settings for Bandwidth Checks

Appendix C: Performance Verification
i.
CHECK
- Trace shift of 0.5 division or less.
j.
Press in the SAVEICONT button to select CONT
k. Position the trace 0.5 division above the bottom horizontal graticule
line using the
CH 2 POSITION control.
I.
Press in the
SAVEICONT button to select SAVE.
m. CHECK - Trace shift of 0.5 division or less.
n. Press in the
SAVEICONT button to select CONT
o. Set the Vertical MODE switch to CH 1
p. Repeat steps g through m for CH 1 trace.
Step 6: Check Bandwidth
a. Set:
VOLTSIDIV (both) 2 mV
AC-GND-DC (both) DC
A
SECIDIV
0.2 ms
BW LIMIT
Off (button out)
STOREINON-STORE
NON-STORE
(button
out)
b. Connect the leveled sine wave generator output via a 50
fl precision
cable and a 50
fl termination to the CH 1 OR X input connector.
c. Set the generator to produce a 50 kHz, six division display.
d. CHECK
- Display amplitude is 4.2 divisions or greater as the gener-
ator output frequency is increased up to the value shown in Table
A-1 0 for the corresponding VOLTSIDIV switch setting.
Table A-1 0: Settings for Bandwidth Checks
VOLTSIDIV
Generator
Switch Setting Output Frequency
2 mV
80 MHz
5
mV to 0.5 V 100 MHz
e. Repeat parts c and d for all indicated
CH 1 VOLTSIDIV switch
settings, up to the output-voltage upper limit of the sine wave gener-
ator being used.
f.
Move the cable from the
CH 1 OR X input connector to the CH 2 OR
Y input connector.
g. Set the Vertical
MODE switch to CH 2.
h. Repeat parts c and d for all indicated CH 2 VOLTSIDIV switch
settings, up to the output-voltage upper limit of the sine wave gener-
ator being used.