Tektronix TDS5000B Series Service Manual

Removal and Installation Procedures
TDS5000B Series Service Manual
6--35
1. Locate module to be removed: Locate the CDRW assembly in the locator
diagram Internal Modules, Figure 6--6, on page 6--19. Note the location of
cables and cable connectors see Figure 6--16 on page 6-- 32. Additional
modules to be removed:
H Trim (all except front panel and acquisition)
H Right side cover
H Printer frame
H Floppy disk drive
2. Orient the oscilloscope: Set the oscilloscope so the bottom is down on the
work surface and the right side panel is facing you.
3. Remove the CDRW Disk Drive assembly: See Figure 6--19, on page 6--37.
a. Verify that the oscilloscope is powered off.
b. Remove the T-15 Torxdrive screw that secures the CDRW Disk Drive
assembly to the chassis.
c. Pull the CDRW Disk Drive assembly away from the chassis far enough
to disconnect the cables See Figure 6--19.
4. Remove the CDRW Drive from the assembly: See Figure 6--18 .
a. Remove the four Phillips screws that secure the drive to the bracket.
b. Gently pull the drive away from the connector and remove the drive
from the bracket.
CDRW Disk Drive

Tektronix TDS5000B Series Specifications

General

Brand	Tektronix
Model	TDS5000B Series
Category	Test Equipment
Language	English