How to troubleshoot a Tektronix TDS5000B Test Equipment oscilloscope that will not power on?
If your Tektronix Test Equipment oscilloscope will not power on, first check the power cord connection to ensure it is properly plugged in. If the power cord is correctly connected, the issue might be a faulty power supply, which would require replacement.
General| Channels | 2 or 4 |
|---|---|
| Vertical Resolution | 8 bits |
| Display Type | Color LCD |
| Vertical Sensitivity | 1 mV/div to 10 V/div |
| Input Coupling | AC, DC, GND |
| Timebase Accuracy | ± 50 ppm |
| Operating Temperature | 0 °C to +50 °C |
| Bandwidth | up to 1 GHz |
| Sample Rate | up to 5 GS/s |
| Display Size | 10.4 inches |
| Input Impedance | 1 MΩ ± 1% |
| Trigger Types | Edge, Pulse Width, Logic, Runt, Timeout, Setup/Hold |
| Maximum Input Voltage | 300 V (DC + peak AC) |
| Interface | USB, GPIB, Ethernet |
To Next Page